Network relay module

PARNIK-IP-C8

Switch eight independent relay outputs from an industrial controller over Ethernet or RS-485.

Read the engineering report

PARNIK-IP-C8 network relay development prototype with display and terminal connections
PARNIK-IP-C8 development prototype

How it works

A PLC or supervisory system sends a Modbus TCP command over Ethernet or a Modbus RTU command over RS-485. The module processes the command and drives the selected relay output.

Integration

Designed to serve as a standalone network relay or an output expansion module in a control panel.

See the architecture

Applications

Intended uses include building services, greenhouse ventilation and distributed industrial control.

Explore intended uses

Technical overview

Outputs Eight independently controlled relay channels
Ethernet Modbus TCP for commands from a networked controller
Serial Modbus RTU over RS-485 for field communication
System role Standalone network controller or distributed output module
Installation concept Panel installation with a DIN-rail-oriented mechanical design
Development status Engineering phase completed. Production release remains pending.

From command to relay contact

Ethernet and RS-485 interfaces feed the controller, which drives the eight relay outputs

The communication interface receives the switching command. The controller identifies the requested output and updates its relay through the driver stage.

Engineering and panel integration

The design separates the power supply, controller, communications, output drivers and relay contacts. This gives a panel designer two integration paths. A supervisory controller can address the module over the Ethernet LAN using Modbus TCP, or a serial master can communicate over RS-485 using Modbus RTU.

Installation and service access

The mechanical review covered connector access, enclosure compatibility and servicing in a DIN-rail panel. PCB work addressed component placement, routing and separation of electrical domains. Production drawings and approved load ratings will define the final installation requirements.

Intended applications

The output stage is intended for distributed control of ventilation, lighting, heating and pumps in facilities and building-management systems. Agricultural applications include greenhouse ventilation and poultry-house environmental control. Load selection and any external switching equipment depend on the released electrical specifications.

Prototype verification and release work

The development team evaluated relay switching, Ethernet and RS-485 communications, and Modbus TCP and RTU operation. PLC and SCADA compatibility was assessed at protocol level. The release plan calls for a controlled register map, per-channel and simultaneous switching tests, representative integration tests, thermal and endurance measurements, compliance testing and pilot acceptance.

Development updates

November 2026 · Engineering development completed. Prototype switching and communications were evaluated. Production qualification and a controlled pilot remain ahead.

Read the full progress report →

Discuss an integration

Tell our engineering team about your controller, communication interface and switching requirements.

Contact the team