Network relay module
Switch eight independent relay outputs from an industrial controller over Ethernet or RS-485.
A PLC or supervisory system sends a Modbus TCP command over Ethernet or a Modbus RTU command over RS-485. The module processes the command and drives the selected relay output.
Designed to serve as a standalone network relay or an output expansion module in a control panel.
Intended uses include building services, greenhouse ventilation and distributed industrial control.
| Outputs | Eight independently controlled relay channels |
|---|---|
| Ethernet | Modbus TCP for commands from a networked controller |
| Serial | Modbus RTU over RS-485 for field communication |
| System role | Standalone network controller or distributed output module |
| Installation concept | Panel installation with a DIN-rail-oriented mechanical design |
| Development status | Engineering phase completed. Production release remains pending. |
The communication interface receives the switching command. The controller identifies the requested output and updates its relay through the driver stage.
The design separates the power supply, controller, communications, output drivers and relay contacts. This gives a panel designer two integration paths. A supervisory controller can address the module over the Ethernet LAN using Modbus TCP, or a serial master can communicate over RS-485 using Modbus RTU.
The mechanical review covered connector access, enclosure compatibility and servicing in a DIN-rail panel. PCB work addressed component placement, routing and separation of electrical domains. Production drawings and approved load ratings will define the final installation requirements.
The output stage is intended for distributed control of ventilation, lighting, heating and pumps in facilities and building-management systems. Agricultural applications include greenhouse ventilation and poultry-house environmental control. Load selection and any external switching equipment depend on the released electrical specifications.
The development team evaluated relay switching, Ethernet and RS-485 communications, and Modbus TCP and RTU operation. PLC and SCADA compatibility was assessed at protocol level. The release plan calls for a controlled register map, per-channel and simultaneous switching tests, representative integration tests, thermal and endurance measurements, compliance testing and pilot acceptance.
November 2026 · Engineering development completed. Prototype switching and communications were evaluated. Production qualification and a controlled pilot remain ahead.
Tell our engineering team about your controller, communication interface and switching requirements.